Tinker Board : CodeTyphone

출처

• CT on Ubuntu 16.04 armhf

컴파일하는 동안 ‘out of memory’을 방지하기 위해 스왑 파일을 활성화

$ sudo apt-get install -y dphys-swapfile

dphys-swapfile 서비스 실행

$ sudo /etc/init.d/dphys-swapfile start
Starting dphys-swapfile (via systemctl): dphys-swapfile.service==== AUTHENTICATING FOR org.freedesktop.systemd1.manage-units ===
Authentication is required to start 'dphys-swapfile.service'.
Authenticating as: linaro,,, (linaro)
==== AUTHENTICATION COMPLETE ===

"sudo" 루트 권한 부여

$ sudo vi /etc/sudoers

linaro ALL=(ALL) NOPASSWD: ALL

CodeTyphon 다운로드

$  wget http://www.pilotlogic.com/codetyphon/zips/CodeTyphonIns.zip

CodeTyphon 압축 해제

$ unzip CodeTyphonIns.zip

CodeTyphon 설치 스크립트 실행

$ cd CodeTyphonIns/
$ ./install.sh 
 
====================================================
             CodeTyphon Studio 
            Version 6.50 (GEN 6)
   Installation for: Linux-Solaris-FreeBSD-MacOS
====================================================
 
   0) Install CodeTyphon Studio
 
   9) Exit
 
>>> Select an action (press 0..9 key): 0

0번 선택 ( 0) Install System Libraries )

====================================================
  CodeTyphon Studio 6.50 Setup for Linux32
   Settings: Platform=gtk2  Multiarch Mode=0
====================================================
   
   0) Install System Libraries
   1) Run CodeTyphon Center (CTC)
   
     11) -- Platform (widget) Setup
     12) -- Multi-Architecture Setup
   
   3) Remove FreePascal
   4) Remove and Build FreePascal
   
   5) Remove Typhon IDE
   6) Remove and Build Typhon IDE
   
   7) Remove ALL
   8) Remove and Build ALL
   
   9) EXIT
   
>>> Select an action (press 0..9 key): 0

8번 선택 ( 8) Remove and Build ALL )

====================================================
  CodeTyphon Studio 6.50 Setup for Linux32
   Settings: Platform=gtk2  Multiarch Mode=0
====================================================
   
   0) Install System Libraries
   1) Run CodeTyphon Center (CTC)
   
     11) -- Platform (widget) Setup
     12) -- Multi-Architecture Setup
   
   3) Remove FreePascal
   4) Remove and Build FreePascal
   
   5) Remove Typhon IDE
   6) Remove and Build Typhon IDE
   
   7) Remove ALL
   8) Remove and Build ALL
   
   9) EXIT
   
>>> Select an action (press 0..9 key): 8

9번 선택 ( 9) EXIT )

====================================================
  CodeTyphon Studio 6.50 Setup for Linux32
   Settings: Platform=gtk2  Multiarch Mode=0
====================================================
   
   0) Install System Libraries
   1) Run CodeTyphon Center (CTC)
   
     11) -- Platform (widget) Setup
     12) -- Multi-Architecture Setup
   
   3) Remove FreePascal
   4) Remove and Build FreePascal
   
   5) Remove Typhon IDE
   6) Remove and Build Typhon IDE
   
   7) Remove ALL
   8) Remove and Build ALL
   
   9) EXIT
   
>>> Select an action (press 0..9 key): 9

실행